Charge The Battery; Insert The Ink Cartridge - Trodat DRYTEQ SET Manual De Uso

5.2.1 Charge the battery

1. Always keep the device turned off while charging.
2. Unroll the accessory cable completely.
3. Insert the USB plug with the C interface into the
USB-C socket of the UV curing unit and the
USB plug into the charger.
During charging, the status indicator glows red.
The battery is fully charged (takes 4 hours)
when the status indicator glows green.
Note
Always disconnect the device from the
power supply when it is fully charged.

5.2.2 Insert the ink cartridge

Danger
Ink can cause an allergic skin irritation.
Wear disposable gloves made of nitrile
rubber.
1. Remove the bag and tear it open using the
tear-off tab.
2. Unzip the zipper and remove the ink cartridge.
3. Make sure to close the bag.
4. Gently hold the cartridge at the uncovered ends
with two fingers.
5. Slowly pull the cartridge cover off in one direction.
Note
Avoid touching the ink.
6. Take the stamp, remove the closing cap and push
the handle down slightly .
12
EN
13
EN