Cleaning; Troubleshooting - Trodat DRYTEQ SET Manual De Uso

7 Cleaning

Clean the Trodat dryteq stamp with a damp cloth.
Text plate
Changing ink
Clean the text plate before inserting a new
ink cartridge with a different colour.
This can be done by:
• Stamping with no ink cartridge inserted
several times.
• Alternatively use a piece of adhesive
tape to remove ink residues by repeatedly
sticking the tape onto the stamp and
then tearing it off.

8 Troubleshooting

Defect
Battery status
light does not
turn on
Push button
does not react
Battery status
light is
flashing red
Push button
does not react
Battery status
light is
flashing yellow
Push button
does not react
Battery status
light is
flashing blue
16
EN
Possible
Solution
cause
Device is
Turn device on
turned off
Battery is Charge the
almost dead device
Device is in Press the push
energy-saving button or the
mode on/off switch
Device is Send device to
defective manufacturer
Battery charge Charge the
is too low device
Wait for the
Device is in the phase to end
cooling phase (2.5 to
10 seconds)
Operating
Operate the
temperature is
device in the
outside the per-
permitted tem-
missible range
perature range
of 0°C to 40°C
UV LEDs are Send device to
defective manufacturer
17
EN