Blackmagic Design Teranex Mini IP Video 12G Manual De Instalación Y Funcionamiento página 26

NOTE The IP address of the created IP Videohub will share the same IP address of
your computer.
Now that your IP Videohub is created, you can see it in the home page. Click on the
IP Videohub's icon to open the settings. Here is where the inputs and outputs are defined for
the Videohub server. This is important because it tells Blackmagic Videohub Control what all
the sources and destinations are so that you can route them.
Create an IP Videohub so you can route source and
destination units using Blackmagic Videohub Control software
To set the inputs and outputs for the IP Videohub:
1 Click on the 'inputs' tab. This lists the number of inputs you defined when
creating the IP Videohub. Now you will need to assign source units to each
input. You will see an icon on the right side of each input name. Click on the
icon to the right of the 'input 1' label.
2 A new window will open showing a list of all source units connected to the network.
Choose a source for input 1.
If the source unit does not appear in the list, you can add it manually by entering its IP address.
After selecting the source unit, click 'save'.
To assign destination units to each output, simply click on the 'outputs' tab and follow the same
instructions set out above but for the outputs instead of the inputs. Click 'save' after you have
finished setting your inputs and outputs.
TIP If you gave your source and destination units a custom name in Blackmagic Teranex
Setup, the inputs and outputs list will display their custom labels.
Setting up and Routing an IP Videohub 26 26