Extreme Operating Conditions; After Use; Cleaning And Disinfection - Dräger Panorama Nova S Instrucciones De Uso

Extreme operating conditions

Low temperatures
If it is not already coated, treat the inside of the visor with "klar-pilot"
anti-misting gel to prevent it from fogging up
visors.
High temperatures/Thermal cycling
If bubbles appear in the visor, it is a sign that the visor is becoming
soft. In this case, leave the danger zone immediately, as the
breathing connection can start to leak.
For visors marked PC/CC, the coating of the visor may blister and
come off in places. The function of the breathing connection will not be
restricted as a result. It will continue to be usable until the end of the
deployment. Replace the visor after use.
Chemicals
Some substances can be absorbed by the material of the breathing
connection or may even diffuse through it. Further information can be
obtained from Dräger.
1)
. Do not wipe coated
WARNING

After use

Disconnect the demand valve:
Press the button (4) and
simultaneously remove the demand
valve (5).
Remove the breathing connection:
Pull back both of the mask / helmet
adapters (6) and fold back from the
helmet.
1)
Release the helmet .
Maintenance
Always test for leaks after servicing and/or replacing components.

Cleaning and disinfection

Before cleaning, remove any accessories from the breathing
connection and clean them separately
The breathing connection must be cleaned and disinfected after every
use.
The mask body must be cleaned sufficiently thoroughly that no
residues from skin care products remain on it.
Otherwise there could be a loss of elasticity in the sealing area and
the breathing connection will no longer sit correctly.
Failure to heed this warning could result in poisoning or death.
1) Note the corresponding Instructions for Use.
6
4
1)
.
WARNING
5
13