Amana ARGS7650 Serie Manual Del Propietário página 11

Converting Type 1 Pressure Regulator for Use with
Natural Gas
1. Remove pressure regulator cap using a
wrench.
2. Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic
insert firmly into hole in pressure regulator cap.
• Insert must show "NAT" or be blank.
4. Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of regulator.
Converting Type 2 Pressure Regulator for Use with
Natural Gas
1. Remove pressure regulator cap using a
wrench.
2. Reverse pressure regulator cap.
• Insert shows "NAT" or is blank.
3. Place pressure regulator cap on pressure regulator
and tighten.
Converting Surface Burners for Use with
Natural Gas
1. Remove access covers located under burner control
panel.
• Each cover is attached with a screw.
2. While facing range front, turn orifice hoods clockwise
1½ to 2 turns.
• Use ½ inch open end or 90° offset open end
wrench.
• Do not over tighten orifice hoods. If orifice hoods
are over tightened, gas supply can be cutoff or
orifice hoods can strip.
A B
A—Access covers
B—Orifice hood
C—Air shutter
3. Adjust air shutter using small screw driver.
• Slide air shutter until shutter is approximately
1 / inch open.
8
4. Replace access cover and screw.
7
/ inch
8
7
/ inch
8
C
Converting Oven Burner for Use with
Natural Gas
1. Remove storage drawer.
• See "Removing Storage Drawer" section.
2. Locate and remove 2 screws attaching Z-shaped
cover plate.
• Cover plate located in center, rear of storage drawer
cavity.
• Removing cover plate exposes oven burner orifice
and air shutter.
3. Turn orifice hood counterclockwise 2 full turns.
4. Replace cover plate and storage drawer.
Converting Broiler Burner for Use with
Natural Gas
1. Locate orifice spud attached adjacent to pressure
regulator and remove for later use.
• Orifice spud used for natural gas is brass and is
stamped "52".
2. Open oven door and locate broiler burner on oven
ceiling.
• Remove oven door to make conversion easier. See
"Removing Oven Door" section.
3. Remove 2 screws securing front of burner to oven
ceiling and remove broiler.
• Be careful not to damage ignitor as you remove
broiler.
4. Unscrew LP/Liquid Propane burner spud stamped
5
"58" with / inch socket wrench and replace with
16
natural gas burner spud stamped "52".
5. Reinstall broiler and, if necessary, oven door.
11