Pressure Regulator Location; Testing For Gas Leaks; Seal Openings - Amana ARGS7650 Serie Manual Del Propietário

A—To regulator
B—Adaptor
C—Flexible connector
D—Manual shutoff
E—¾ inch service pipe stub

Pressure Regulator Location

Remove rear access cover to expose pressure regulator.
A—12 inches

Testing for Gas Leaks

After final gas connection is made, turn on manual gas
valve and test all connections in gas supply piping and
range for gas leaks.
To avoid property damage or serious personal injury,
never use a lighted match to test for gas leaks.
1. Place soap suds on connection.
2. If bubbles appear, shut off gas supply valve.
3. Tighten joint if leak is at factory fitting.
4. Retest connection for leak after tightening.

Seal Openings

Openings in wall behind the range or on floor under range
A
must be sealed before sliding range into position.
13
A—1 1 / inches
8
1
B—4 / inches
3
WARNING
• Bubbles appear if leak is present.
• If leak is not at factory fitting, unscrew, apply more
joint compound, and tighten to correct leak.
• Retest any connections that were disturbed.
A
B