Interrupt Self-Clean Cycle
1. Press OVEN CANCEL pad.
2. When oven has cooled to a safe temperature, door
will unlock and can be opened.Delayed Self-Cleaning
Delayed Self-Cleaning
• A small amount of smoke is normal when cleaning.
Excessive smoke may indicate there is a faulty gasket
or too much food residue has been left in oven.
• Clean oven before it gets too dirty. Wipe up large spills
before self-cleaning.
• Do not use cleaning cycle if oven light cover is not
properly in place.
WARNING
To avoid risk of smoke damage or fire, clean excess
spills from oven interior and under oven bottom before
self-cleaning range. Wear hand protection to avoid
injury from sharp edges.
1. Pull oven bottom forward and lift out of range.
2. Wipe out burner area with a cloth and warm
soapy water.
3. Dry area thoroughly and replace oven bottom.
CAUTION
To avoid risk of personal injury, do not touch oven
vents or areas around vents during self-cleaning.
These areas can become hot enough to cause burns.
1. Prepare oven for self-cleaning.
• Remove oven racks and all cooking utensils from
oven.
• Clean excess spills from oven interior.
• Remove items from range top and backguard.
These areas can become hot during self-cleaning
cycle.
2. Press CLEAN pad.
• "CLEAN", "TIME", and "----" display.
3. Press
or
pad until desired amount of cleaning
time is displayed.
• "3:00" displays when
• Increase or decrease cleaning time in 5 minute
increments.
• Clean can be set from 2 to 4 hours. Minimum
recommended cleaning time is 3 hours.
or
is pressed.
4. Press STOP TIME pad.
5. Press
or
pad until desired stopping time
appears in display.
• Starting time is automatically calculated based on
amount of cleaning time and stop time.
• "DELAY", "CLEAN, "STOP", "TIME", "CLEAN", and
"LOCK" display. "LOCK" flashes in display when
automatic door latch is locking.
• To view remaining cleaning time, press and hold
CLEAN pad.
• To view calculated stop time, press STOP TIME
pad.
• When cleaning time has elapsed, oven
automatically turns off and display returns to
time-of-day. End-of-cycle signal sounds.
• When oven cools to a safe temperature, door latch
opens and "LOCK" light flashes while opening.
After door latch opens, "LOCK" light no longer
displays and door can be opened.
Interrupt Self-Clean Cycle
1. Press OVEN CANCEL pad.
2. When oven has cooled to a safe temperature, door
will unlock and can be opened.
Child Lock Out
This feature disables oven control. Surface elements can
be used while child lock out is on.
1. Press and hold BAKE and CLOCK pads
simultaneously.
• "OFF" displays briefly.
2. Repeat step 1 to cancel child lock.
22