Operating Instructions - Industrial Air IH1393075 Manual Del Operador

BREAK-IN OF THE PUMP
NOTE: The pump is shipped with break-in oil which should be
changed after the first 8 hours of operation.
NOTE: When references are made to gasoline engine
operations, refer to the engine manual for proper
procedure.
1. Before starting the compressor for the first time, ensure
proper oil level in the gasoline engine crankcase.
WARNING:
Risk of carbon monoxide
poisoning. Engine exhaust contains carbon
monoxide, an odorless and deadly poison. DO
NOT operate in an enclosed area. DO NOT mount
or operate in an enclosed vehicle, such as a van.
2. Check the oil level in the pump (see "Checking the Oil" in the
maintenance section).
3. Fill the tank of the gasoline engine with unleaded gasoline.
DO NOT MIX OIL WITH THE GASOLINE.
4. Move the unloader lever to the manual start position (see D).
5. Open the petcock (see F).
CAUTION:
propel debris that may cause eye injury. Wear safety
goggles when opening petcock.
6. Start the gasoline engine according to the instructions in
the engine manual. Move the unloader lever to the run
position (see C). Run the compressor for about 30 minutes to
break in the internal parts.
NOTE: If the unit does not operate properly, SHUT DOWN
IMMEDIATELY, and contact your nearest Service
Center or call the factory's Customer Service
Department. DO NOT return the unit to the store
where it was purchased.
7. Shut off the gasoline engine. Close the petcock (see E).
Connect your air hose to the tank outlet. Check that all
connections are tight. A small leak in any of the hoses,
transfer tubes, or pipe connections will substantially reduce
the performance of your air compressor.
DAILY START-UP
1. Check the oil level in the gasoline engine crankcase. Add
oil as necessary. See instructions in the engine manual.
2. Check the oil level in the pump (see "Checking the Oil" in the
maintenance section).
3. Fill the tank of the gasoline engine with unleaded gasoline.
4. Move the unloader lever to the start position (see D).
5. Close the tank petcock (see E).
6. Start the gasoline engine according to the instructions in
the engine manual. Run the engine for about one minute
to warm up the pump, then move the unloader lever to the
run position (see C). The pump will begin to fill
the tank with air.
7. Do not run the starter motor for more than 5 seconds at a
time. Always allow resting for 10 seconds before each
starting attempt.
WARNING:
the gasoline engine, transfer tube, and the pump. To
prevent burns or other injuries, DO NOT touch these
items while the engine is running. Allow them to
cool before handling or servicing. Keep children
away from the compressor at all times.

OPERATING INSTRUCTIONS

Escaping air and moisture can
High temperatures are generated by
NOTE: If the unit does not operate properly, SHUT DOWN
IMMEDIATELY, and contact your nearest Service
Center or call the factory's Customer Service
Department. DO NOT return the unit to the store
where it was purchased.
REPEATED STARTUPS
Move the unloader lever to the start position (see D), to
relieve pressure in the pump and lines. It is important to do this
because if air remains trapped in the pump, it creates a blockage
that makes restarting the compressor difficult or impossible.
Do not run the starter motor for more than 5 seconds at a
time. Always allow resting for 10 seconds before each starting
attempt.
COLD WEATHER STARTING
In cold weather check that the air filters are clean.
NOTE: Use synthetic blend, non-detergent air compressor oil.
Open the petcock (F) to depressurize the tank to zero PSI
before starting. If the compressor will not start, relocate it in a
warmer location.
SHUTDOWN
1. Shut off the gasoline engine.
2. Reduce pressure in the tank through the outlet hose. You
can also pull the relief valve ring (see G) and keep it open to
relieve pressure in the tank.
CAUTION:
propel debris that may cause eye injury. Wear
safety goggles when opening petcock.
3. Wear protective eyewear and open the petcock (see F)
at the bottom of the tank to allow moisture to drain from
the tank.
C
Run
Position
D
Start
Position
Open Close
F
E
6 - ENG
Escaping air and moisture can
G
200-2967