Service Spark Plug; Service Air Cleaner - Briggs & Stratton ELITE Serie Manual Del Propietário

MAINTENANCE
3. Clean area around oil drain plug.The oil drain plug is
located at base of engine, opposite carburetor (Figure 17).
Figure 17 — Oil Drain Plug and Oil Fill Cap
Oil Drain Plug
4. Remove oil drain plug and drain oil completely into a
suitable container.
5. Reinstall oil drain plug and tighten securely. Remove oil
fill cap.
6. Slowly pour oil (about 20 oz.) into oil fill opening to
the point of overflowing at oil fill cap (Figure 17). DO
NOT overfill.
7. Reinstall oil fill cap. Finger tighten cap securely.
8. Wipe up any spilled oil.

Service Air Cleaner

Your engine will not run properly and may be damaged if
you run it with a dirty air cleaner.
Replace the air cleaner every 25 hours of operation or
once each year, whichever comes first. Replace more often
if operating under dirty or dusty conditions.
To service the air cleaner, follow these steps:
1. Loosen screw and tilt cover down (Figure 18).
Figure 18 - Air Cleaner
2.
3.
4.
5.
6.

Service Spark Plug

Change the spark plug every 100 hours of operation or
once each year, whichever comes first.This will help your
Oil Fill Opening
engine to start easier and run better.
1.
2.
3.
4.
5.
19
Carefully remove cartridge assembly.
To clean cartridge, gently tap pleated paper side on a
flat surface.
Reinstall clean or new cartridge inside cover.
Insert cover's tabs into slots in bottom of base.
Tilt cover up and tighten screw securely to base.
Clean area around spark plug.
Remove and inspect spark plug.
Check electrode gap with wire feeler gauge and set
spark plug gap to 0.030 inch (0.76mm) if necessary
(Figure 19).
Figure 19 — Spark Plug
Replace spark plug if electrodes are pitted, burned or
porcelain is cracked. Use the recommended
replacement plug.
Install spark plug and tighten firmly.