Ariston GENUS PREMIUM HP 45 Instrucciones De Instalación Y De Utilización página 45

menús de selección - regulación - diagnóstico
description
7 TEST & UTILITIES
7 0 0 Function test - Cleaning
turn the encoder to select the
operating mode
7 0 1 Bleed cycle
8 PARAMETER FOR TECHNICAL ASSISTANCE
8 1 Entering access code
8 2 BOILER
8 2 0 NOT ACTIVE
8 2 1 Fan status
8 2 2 Fan speed (x100) rpm
8 2 3 Circulation pump speed
8 2 4 Distribution valve position
8 2 5 Water fl ow rate (l/min)
8 2 6 NOT ACTIVE
8 3 BOILER TEMPERATURE
8 3 0 Heating adjustment temperature (°C)
8 3 1 Heating fl ow temperature (in °C)
8 3 2 Heating backfl ow temperature (in °C)
8 3 3 Domestic hot water temperature (in °C)
8 4 SOLAR APPLIANCE AND TANK
8 4 0 Accumulated measured temperature
8 4 1 Solar collector temperature
8 4 2 Solar appliance water input temperature
8 4 3 Solar appliance low tank sensor temperature
8 4 4 Layered tank set temperature
8 4 5 Total circulation pump operating time delay for solar appliance
8 4 6 Total solar collector overheating time delay
8 5 SERVICE - TECHNICAL ASSISTANCE
8 5 0 Time remaining before next service
setting
8 5 1 Service warning authorisation
8 5 2 Clearing the service warning
8 5 3 NOT ACTIVE
8 5 4 PCB hardware version
8 5 5 PCB software version
8 5 6 PUS peripheral device interface software version
settings - adjustment - problem identifi cation menus
value
t-- = funct. at Max
heating power
t -- = funct. at Max DHW
power
t -- = funct. at Min power
press Menu
0 = OFF
1 = ON
0 = OFF
1 = Low Speed
2 = Hight Speed
0 = Domestic hot water
2 = Heating
0 to 60 (months)
ON or OFF
Reset
OK = yes
ESC = no
t-- activation can also be obtained by pressing
the Reset button for 10 seconds. The function
is deactivated after 10 minutes or by pressing
Esc
222 turn the encoder clockwise to select 234 and
press the M button
ENU
activated only with the solar kit connected or
external tank
24 once the parameter is set, the boiler will show
the user the interval before the next service
OFF once the service has been performed, set the
parameter to clear the warning
45