Starting Your Air Conditioner - Rotary Control - Whirlpool CA10WXP0 Manual De Uso Y Cuidado

To select the fan speed (in Cool or Power Saver
mode only):
Press TURBO, HIGH or LOW.
SPEED
To raise the temperature:
Press the up arrow button to raise the temperature 1º until it
reaches 86°F (30ºC).
To lower the temperature:
Press the down arrow button to lower the temperature 1º until it
reaches 64°F (18ºC).
To set Timer for a 1- to 24-hour delay until air conditioner
turns off (the air conditioner must be On):
1. Press TIMER. Indicator light on air conditioner will flash.
2. Press the up arrow or down arrow button to change delay
time (1 to 24 hours).
3. Press TIMER again or wait 10 seconds. Indicator light on air
conditioner will remain on.
To set Timer to turn on air conditioner, keeping previous
settings:
1. Turn off air conditioner.
2. Press TIMER. Indicator light on air conditioner will flash.
3. Press the up arrow or down arrow button to change delay
time (1 to 24 hours).
4. Press TIMER again or wait 10 seconds. Indicator light on air
conditioner will remain on.
To set Timer to turn on air conditioner, changing the
previous settings:
1. Turn on air conditioner.
2. Adjust MODE to Auto, Cool, Fan Only, or Power Saver.
3. Adjust FAN SPEED to Turbo, High or Low.
4. Adjust temperature between 64°F (18ºC) and 86°F (30ºC).
5. Wait 3 seconds before turning off air conditioner.
6. Press TIMER. Indicator light on air conditioner will flash.
7. Press the up arrow or down arrow button to change delay
time (1 to 24 hours).
8. Press TIMER again or wait 10 seconds. Indicator light on air
conditioner will remain on.
10
Turbo
High
FAN
Low
Timer
Starting Your Air Conditioner —
Rotary Control
Model 1
Model 2
1. Remove clear protective film from front panel badge (on
some models).
2. Set exhaust control. See "Exhaust Control (on some
models)."
3. Select the fan speed. See "Fan Speed."
4. Select temperature. See "Temperature."
Exhaust Control (on some models)
Push the Exhaust control CLOSED for maximum continuous
cooling. Pull the Exhaust control OPEN to allow you to draw stale
or smoky air from the room.
Open - pull to exhaust room air to the outside
Closed - push to circulate room air
NOTE: The Exhaust control will function only when the Fan
Speed control is operating.