ProMariner ProNauticP Serie Manual De Instrucciones página 16

15
Setup and Operation
LED Status Indicator Center
Feature
AC power
Auto temp control
Active PFC
Volts
Amps
Charger output
Self test
OK
Auto Maintain
Charge
Conditioning
NOTE: This LED configuration indicates that the charger is functioning normally and does not
need any further attention. If the RED "Fault" LED illuminates ,or any of the "Charger Conditions"
LED's are illuminated, consult the Troubleshooting section of this manual.
OPERATIONAL NOTE: Your ProNauticP Charger has built in safety features that can cause the unit
to shut down if it senses out of parameter operations such as over-voltage and high temperatures.
See the Troubleshooting section of this manual for more details in the event this occurs.
Optional Remote Display
Optional Remote
Power LED
Fault LED
Backlight button
Alarm Button
Setup
Enter
^
When the optional remote is installed, it will display the current status of the charger along
with the voltage and amperage.
1. The blue LED is illuminated when the power is ON
2. BACKLIGHT can be set to ON or OFF by toggling the BACKLIGHT button, default is ON
3. ALARM can be silenced or audible by toggling the ALARM button, default is audible
4. During the Auto Maintain (Energy Conservation Mode) only the Power, Auto Maintain and
Standby LED will be on - to view full display, including voltage and current, press any
function button
LED Color
blue
green
green
display system voltage
display output amperage
percentage of charge
blue
green
green
green
green
blue
red
toggle between ON and OFF by pushing repeatedly, default is ON
toggle between silent and audible by pushing repeatedly, default is audible
toggle between silent and audible by pushing repeatedly, default is audible
selects both "scrolling mode" and activates chosen feature
(see optional remote programming section)
controls for scrolling in "scroll mode"
Function
with remote temp sensor connected
equal to the charge in the selected profile
based on state of charge
based on state of charge
if self test was initiated
following successful self test
based on state of charge
based on state of charge
based on state of charge
indicates power is ON
indicates a fault