Toto TES100DA Manual De Instalación Y Del Propietario página 10

INSTALLATION PROCEDURE - Battery Box
[DC Type]
1. Select position for the battery case.
Make sure the power supply cable is capable
of reaching the controller.
2. Mark the location of the mounting holes.
3. Drill 2 holes. Depth : 1"(25mm)
Size : 7/64" (3mm) without anchor
4. Insert a self-tapping screw into upper hole until
there is a 1/4"(6mm) gap between head of
screw and wall.
Use anchors if necessary.
5. Hang the battery case on the screw.
6. Insert a self-tapping screw through bottom hole
of case and tighten.
7. Connect power cord to controller.
1/4" (7mm) with anchor
Power cord
Self-tapping screw
9
1/4"
(6mm)