Front Panel Layout; To Set The Temperature (Setpoint) - ero electronic ELK Guía Del Usario

3.4. Front Panel Layout

Beacons:-
ALM (flashing or steady) Alarm active (Red)
OP1 Lit when output 1 is ON (normally heating)
OP2 Lit when output 2 is ON (normally cooling )
OP3 Lit when output 3 is ON (ETK only)
OP4 Lit when the changeover relay output is ON
SPX Alternative setpoint in use (SP2)
REM Remote setpoint or communications active
RUN Timer/programmer running
RUN (flashing) Timer/programmer in hold
MAN Manual mode selected
Operator Buttons:-
From any view - press to return to the HOME
display.
Press to select a new parameter. If held down
it will continuously scroll through parameters.
▼
Press to change a selection or to decrease a
value.
▲
Press to change a selection or to increase a
value.
28
3.4.1.

To Set The Temperature (Setpoint)

In the HOME display:-
▲
Press to raise the setpoint
▼
Press to lower the setpoint
The new setpoint is entered when the button is
released and is indicated by a brief flash of the
display.
Part number HA028438. Issue 3.0.
Units (if configured)
Measured Temperature
Target Temperature
(Setpoint )
Meter (ELT only)
configurable as:
- Off
- Heat or cool output
- Output (Centre zero)
- Load Amps from CT
- Error signal
Oct-05