To Select Auto, Manual Or Off Mode - ero electronic ELK Guía Del Usario

3.4.3.

To Select Auto, Manual or OFF Mode

▼
Press and hold and
more than 1 second.
This must be done in the HOME display.
1. 'Auto' is shown in the upper
display. After 5 seconds the
lower display will scroll the
longer description of this
parameter. ie ' lo o p m od e –
a u to m an u a l o ff'
▲
2. Press to select 'mAn' or
twice to select 'OFF'. This is
shown in the upper display.
3. When the desired Mode is
selected, do not push any other
button. After 2 seconds the
controller will return to the
HOME display.
If OFF has been selected, OFF will be shown in
4.
the lower display and the heating and cooling
outputs will be off
30
▲
(MAN) together for
t + u
t
t + u
5. If manual mode has been selected, the MAN
beacon will light. The upper display shows the
measured value and the lower display the
demanded output power.
☺
The transfer from Auto to manual mode is
'bumpless'. This means the output will remain
at the current value at the point of transfer.
Similarly when transferring from Manual to
Auto mode, the current value will be used. This
will then slowly change to the value demanded
automatically by the controller.
6. To manually change the power output, press
▲
▼
or to lower or raise the output. The
output power is continuously updated when
these buttons are pressed
7. To return to Auto mode, press
together. Then press
Part number HA028438. Issue 3.0.
▲
▼
and
▼
to select 'Auto'.
Oct-05