Troubleshooting; Optional Accessories - Mafell NFU 32 Manual De Instrucciones

6

Troubleshooting

The determination of the causes of existing defects and their elimination always require
increased attention and caution. Pull out the mains plug beforehand!
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine stops while cutting is in proc-
ess
Burn marks on kerfs
Chip ejection blocked
7

Optional accessories

Guide track, cpl.
➤
Cause
No mains voltage
Carbon brushes worn
Motor protection reacted
Mains failure
The cutter used is unsuitable for the
task or blunt
Wood is too damp
-20-
Elimination
Check power supply
Take the machine to a MAFELL cus-
tomer service shop
See section 4.3
Check power supply
Replace the cutter; change reversible
knives
Ref. No. 201 546