Operating The Machine - Clarke ENCORE Serie Manual Del Usuario

ENGLISH
EN
How To Operate The Machine
When filling machine from the rear, position clear drain
hose against bracket and insert hose as shown in
figure 20B Solution level can be viewed from the back
of the machine.
WARNING: Water solutions or cleaning materials
used with this type of machine can
leave wet areas on the floor surface.
These areas can cause a dangerous
condition for the operator or other
persons. Always put CAUTION signs
near the area you are cleaning.
WARNING: Machines can ignite flammable
materials and vapors. Do not use with
or near flammables such as gasoline,
grain dust, solvents and thinners.
Only use a cleaning concentration
recommended by the chemical
manufacturer.
WARNING: Clarke recommends a maximum water
temperature of 120

Operating The Machine

NOTE: Put the machine in the lowest traverse speed
setting. Use the machine in an area that has no furniture or
objects until you can do the following:
1. Move the machine in a straight direction, forward and
backward.
2. Stop the machine safely.
3. Turn the machine both left and right and return to a straight
direction.
To move the machine, follow this procedure:
1. Release the parking brake (if equipped with
machine).
2. Turn the key switch to the "ON" position
3. Raise the brush to the highest setting.
4. Raise the squeegee.
5. When either the left or right forward/reverse switches
(figure 21, item A) are pushed in, the machine will go
forward.
6. Control the speed of traverse by using the traverse speed
control knob (figure 21, Item C).
7. To stop, release the forward/reverse switch.
8. To reverse the machine, push in the white reverse switch
(figure 21 item B) and either the right or left forward/
reverse switch (figure 21 item A) at the same time.
9. To stop, release the forward/reverse switch.
10. To turn the machine, push the rear of the machine to the
side.
11. When you stop the machine, turn the key switch "OFF",
remove the key and set the parking brake (if equipped).
Page -18-
o F (49 o C).
Clarke ®
Operator's Manual (EN) - Encore S2426 / L2426 / S2426 OBC / L2426 OBC
Figure 20B
B
A
Figure 21
C
A