How To Clean A Dirty Floor - Clarke ENCORE Serie Manual Del Usuario

How To Operate The Machine (cont)
How To Clean A Floor
WARNING: Water solutions or cleaning materials used
with this type of machine can leave wet areas
on the floor surfaces. These areas can cause
a dangerous condition for the operator or
other persons. Always put CAUTION signs
near the area you are cleaning.
To clean a floor follow this procedure:
1. Set the parking brake (if equipped with machine.)
2. Put the water and a cleaning chemical in the clean solution
tank.
3. Release the parking brake (if equipped with machine.)
4. Turn the key switch "ON".
5. Lower the squeegee.
6. Activate the brush switch until correct pressure is achieved.
WARNING: This machine is capable of maximum head
pressure with worn pads or brushes. With
this feature, there is the possibility of
exceeding the recommended brush pressure
on new pads or brushes. This will either
create reoccurring circuit breaker tripping or
the possibility of lost traction and control. The
brush switch should be activated to
accomplish only enough brush pressure for
the job. This will allow longer battery life and
cleaning time.
NOTE: Keep the machine moving when the brush is
rotating on the floor. Pre-wet brush/pad or keep light
pressure on brush until solution flow is adequate to keep
brush/pad from scratching the floor.
To pre-wet brushes you should first turn the speed knob to the
lowest setting on the "L" model. Then on both the "S" and "L"
models, lower brushes until brushes are just touching the floor.
Activate the forward/reverse switch to start motor and solution
flow.
7. Turn the solution knob to the right to activate the flow of
solution. Adjust the flow of clean solution to the flow
desired.
8. Move the machine across the floor in the forward direction.
9. Make a 180° turn.
NOTE: When you make more passes across the floor, let the
brush clean approximately 2 inches (5 cm) of the area already
cleaned by the brush.
NOTE: During most cleaning procedures, apply and remove the
solution in one operation.
How To Clean A Very Dirty Floor
To clean a very dirty floor, follow this procedure:
1. Apply solution to the floor.
2. Do not lower the squeegee. This will keep the vacuum
motor off.
3. Lower the brush or pad and scrub the floor.
4. Scrub the floor again with additional solution and lower the
squeegee.
5. Pick up all the solution with the squeegee.
Clarke ®
Operator's Manual (EN) - Encore S2426 / L2426 / S2426 OBC / L2426 OBC
ENGLISH
EN
- 19 -