Procedures For Transporting Machine - Clarke ENCORE Serie Manual Del Usuario

ENGLISH
EN
Procedures For Transporting
How to Put the Machine Into a Van or Truck
WARNING: This machine is heavy. Get
assistance before attempting
to transport or move it. Use
two able persons to move the
machine on a ramp or
incline. Always move slowly.
Do not turn the machine on a
ramp. Do not stop and leave
the machine on a ramp or
incline. The loading ramp
must be a minimum of 32"
wide.
WARNING: Machines can topple over if
guided over the edges of
stairs or loading docks and
cause injury or damage.
Stop and leave this machine
only on a level surface.
When you stop the machine,
put all switches into their
"OFF" position.
1. Make sure the loading ramp is at least eight
(8) feet (2.5m) long and a minimum of 32" (0.8m)
wide, and strong enough to support the machine.
2. Make sure the ramp is clean and dry.
3. Put the ramp in position.
4. Remove squeegee assembly, brush housing and
brush or pad driver before loading. Clarke
recommends that both the solution tank and
recovery tank are empty before loading.
5. Turn key switch "ON" (on "L" model only).
6. Align the machine on a level surface five (5) feet
(2 m) in front of the ramp.
7. Put the traverse knob at full speed (on "L" model
only).
8. For the" L" machine, push in either one of the
forward/reverse switches while pushing in the
white reverse switch. Back the machine up the
ramp. See figure 1.
9. For the "S" machine, push the machine back-
wards to the top of the ramp.
10. Turn the key switch "OFF".
Page -6-
Clarke ®
Operator's Manual (EN) - Encore S2426 / L2426 / S2426 OBC / L2426 OBC
Figure #1