Fitting The Edger Blade - Stihl FC 55 Manual De Instrucciones

Fitting the Edger Blade

1
: Place the power edger on a
suitable support so that the blade
mounting (1) faces upwards.
FC 55
5
6
4
2
3
: Insert stop pin* or offset
screwdriver* (2) as far as possible in
the bore (3) – push lightly and rotate
it back and forth together with the
thrust washer (4) until the drive shaft
is blocked.
: Fit combination wrench (5) on the
nut (6).
: Loosen and remove the nut
clockwise (left-hand thread).
: Remove the thrust washer.
* see "Guide to Using this Manual"
English / USA
7
6
4
9
8
: Position blade (7) on the thrust
plate (8).
Collar (see arrow) must engage
hole in blade.
: Fit thrust washer (4) on the shaft (9).
: Block the shaft.
: Screw the nut (6) on to the shaft
counterclockwise and tighten down
firmly.
If the cup spring (10) on the nut (6)
becomes fatigued, install a new nut.
10
7
17