Safety Instructions For Assembly - FALMEC Sintesi Manual De Instrucciones

The electromagnetic field of the hob during ope-
ration can affect the operation of magnetisable
objects. Credit cards, life-saving devices, pocket
calculators etc. should not be in the proximity of a
hob when in operation.
Metal objects stored in the drawer underneath the
appliance may become hot in case of prolonged
use. Do not store metal objects in a drawer imme-
diately underneath the hob.
The appliance is equipped with cooling fans. If the-
re is a drawer under a built-in appliance, a separa-
tion must be ensured between the drawer and the
bottom of the appliance, for appropriate hob ven-
tilation and to make sure the fans are not be ob-
structed.
Never use two saucepans or pans on the same
cooking zone, or a rectangular cooking zone, or a
PowerFlex cooking area.
SAFETY DEVICES ON THE COOKER
Safety shutdown
If a cooking area exceeds the maximum time for
operation at the same power, it is automatically
switched off and the indication of the residual heat
is shown.
To reset the cooking area, touch the necessary keys.
low 1 2 3
Power level
Maximum
duration of
8.7 2.0 8.7 6.7
operation in
hours
The cooker switches off automatically if one or
more controls stay covered for more than 10 sec-
onds.
To restore the proper operation:
- remove all objects from the control panel.
- clean the control panel.
- restart the cooker and the concerned area.
Overheating device
Before items of the cooker can overheat, the con-
trol reduces the used power by following this pro-
cedure for protection measures:
4 5 6 7 8 9
5.3 4.3 3.5 2.8 2.3 1.9 1.5
- Deactivation of booster and power booster if
turned on.
- Reduction of the power level set.
- Shutdown of the cooking area concerned.
On the display of the cooking area the message
"E2" is displayed.
It is possible to restore the cooking area when the
default message is off.

SAFETY INSTRUCTIONS FOR ASSEMBLY

Install the cooker after installing kitchen cabinets and basis.
Make sure that worktops have been veneered with thermoresistant
glue in order not to suffer deflections or detachments.
It is forbidden to install the appliance on fridges or freezers, washing
machines, dishwashers, or tumble driers.
ELECTRICAL SAFETY
he electrical system to which the cooker is to be connect-
T
ed must be in accordance with local standards and sup-
plied with earthed connection in compliance with safety
regulations in the country of use. It must also comply
with European standards regarding radio antistatic properties.
Make sure that it can't be possible to touch the power cable of the cook-
er after it has been built-in and that it is not subject to mechanical stress.
The socket used to connect the installed equipment to the electrical
power supply must be within reach: otherwise, install a mains switch to
disconnect the machine when required.
P
Any changes to the electrical system must be carried out by a qualified
electrician.
Do not try to solve the problem yourself in the event of equipment
malfunction, but contact the Dealer or an authorised Servicing Depart-
ment for repairs.
When installing the cooker, disconnect the equipment by
removing the plug or switching off the main switch.
ELECTRICAL CONNECTION
(only intended for qualified personnel)
Disconnect the equipment from mains power network be-
fore carrying out any operation on the cooker.
Make sure that electric wires inside the cooker are not dis-
connected or cut:
in the event of damage, contact your nearest Servicing Depart-
ment.
Refer to qualified personnel for electrical connections.
Connection must be carried out in compliance with the provisions
of law in force.
Before connecting the cooker to the mains power network, check that:
• the mains voltage corresponds with the voltage indicated on the
data plate located inside the cooker;
31