Materials And Tools; Section 3. Install Controller Box; Mount The Controller Enclosure - Zodiac AquaLink Z4 Serie Manual De Instalación

2.3

Materials and Tools

Installation Materials Furnished
• Screw Set (includes Plastic Anchors)
• Metal Mounting Bracket
Tools Needed for Installation
• Power Drill
• 3/16" Drill Bit - Hammer Drill Bit (only necessary to drill into brick or concrete)
• Conduit Fittings
• Wire Nuts
• Wire Crimping Pliers
• Pencil or Marking Pen
• Flat Head Screwdriver
• Phillips Head Screwdriver
• Small Flathead or Slotted Screwdriver
Section 3. Install Controller Box
WARNING
FOR YOUR SAFETY: This product must be
serviced by a professional pool/spa service
technician as described on the front cover of this
manual. The procedures in this manual must be
followed exactly. Failure to follow warning notices
and instructions may result in property damage,
serious injury, or death. Improper installation and/or
operation will void the warranty.
When mounting the controller box in the equipment
pad, instructions must be followed exactly. Read
through the Important Safety Information section
completely before beginning installation and before
operating the equipment.
Before you begin installation, make sure you have the
necessary tools and a suitable location to install the
AquaLink Z4.
NOTE The controller should be located at or near the
equipment pad.
Locate the controller at least five (5) feet or more away
from pool/spa and five (5) feet off the ground. All
national, state, and local codes are applicable.
NOTE For Canadian installations, the controller must
be at least three (3) meters (9.8 feet) away from
the pool/spa
|
AquaLink Z4 Controller Installation Manual
®
3.1
1. Using a flat screwdriver, rotate door tumblers
counter-clockwise to unlock the front cover of the
controller.
2. Open the front cover door and remove the
mounting hardware kit.
3. Using the holes in the bracket as a guide, mark four
(4) dots on the surface where the controller will be
mounted. The four (4) mounting holes are 3-15/16"
(10 cm) apart center to center.
NOTE Make sure to mark out the four (4) holes as
4. Drill four (4) holes in the mounting surface.
5. Press the four (4) plastic anchors firmly into holes.
6. Screw the mounting bracket onto the mounting
surface with the four (4) screws provided.
ENGLISH

Mount the Controller Enclosure

accurately as possible.
Page 7