Triton JOF 001 Instrucciones De Uso página 9

TABLE-MOUNTED OPERATION
• Fitting and operating this router on a router table should
be done in accordance to the literature supplied with
your router table
• This product was designed for efficient and conveni-
ent operation on most router tables, but is particularly
suited to the Triton Router Table
• Router adjustments are made extremely easy using the
SERVICE
• Any damage to the router should be repaired and
carefully inspected before use by qualified repair
personnel. Service or maintenance performed by
unqualified personnel could result in a risk of injury.
• Servicing should only be carried out by authorised
Triton Repair Centres using original Triton replacement
parts. Follow instructions carefully and refer to
'Troubleshooting' for problem identification and advice.
Use of unauthorised or faulty parts may create a risk of
electric shock or injury.
• Triton Precision Tools will not be responsible for any
damage or injury caused by unauthorised repair of the
router or by mishandling of the tool.
Brush replacement
The carbon brushes are a consumable item which should
be inspected periodically and replaced when worn. Failure
to do so may result in damage to the motor.
TROUBLESHOOTING
The following chart contains information designed to assist in diagnosing and resolving router problems.
SYMPTOM
Router will not operate
Router runs slowly
Makes an unusual sound
• The Through Table Winder (18) engages with the
1. With the router disconnected
2. Remove the brushes by
3. If either of the brushes is worn to less than 6mm
Power cord replacement
If the supply cord needs replacing, the task must be
carried out by the manufacturer, the manufacturer's agent,
or an authorised service centre in order to avoid a safety
hazard.
POSSIBLE CAUSE
• No supply of power
• Brushes worn or sticking
• Switch is faulty
• M otor components faulty or short
circuited
• Blunt or damaged cutter
• Variable speed set low
• Motor is overloaded
• Mechanical obstruction
• Armature has shorted sections
Table-mounted Operation / Service / Troubleshooting
unique features described earlier in the manual. Refer to
'Fitting a collet and router bit' and 'Adjusting the depth
of cut'
Table-Winder Connection Point (10) for quick and easy
above-the-table height adjustment when the router is
table-mounted
from power, unscrew the
Brush Caps (2) located on the
front and rear of the motor.
pulling carefully on the
protruding springs.
long, they must both be replaced using genuine Triton
replacement brushes - available from Authorised Triton
Repair Centres.
REMEDY
• Check that power is available at source
• D isconnect power, open brush caps and
ensure brushes move freely in the holders.
Check whether the brushes require
replacing - see Page 9
• Go to www.tritontools.com for your
nearest Triton Approved Service Agent
• Go to www.tritontools.com for your
nearest
Triton Approved Service Agent
• Re-sharpen or replace cutter
• Increase variable speed setting
• Reduce pushing force on router
• Go to www.tritontools.com for your nearest
Triton Approved Service Agent
• Go to www.tritontools.com for your nearest
Triton Approved Service Agent
GB
9