salmson SIRIUX Serie Instalacion Y Puesta En Servicio página 69

Symbol Meaning
The pump is operated via a serial data interface. The "On/Off" function
is not activated at the module. Only
and fault acknowledgement need to be set at the module. The IR oper-
ating and service unit (accessory) can be used to temporarily interrupt
operation at the interface (for checking, for reading out data). With cer-
tain IF Modules, the menu can be re-opened. (The menu can then still be
operated manually even though the module is connected) (see docu-
mentation of the IF Modules)
Pump is running as slave pump.
No change can be made at the display.
The double pump runs in efficiency-optimised peak load operation
(master + slave).
Double pump running in main/standby mode
(master or slave)
Appears on pumps with certain IF Modules (see documentation of IF
Modules) if a signal (sign) is sent from the building management system
to the pump.
The pump is set in the "US units" mode.
Fault-tolerant error matrix activated.
Heating operating mode (for faults, see Chapter 10)
Fault-tolerant error matrix deactivated.
Air-conditioning operating mode (for faults, see Chapter 10)
Menu structure: There are three menu levels. The levels below the indication of
the basic settings are always accessed from level 1 by pressing the control but-
ton for different lengths of time.
• Level 1 - Status indication (indication of the operating status)
• Level 2 - Operation menu (setting the basic functions):
• Press the control button for longer than 1 second
• Level 3 - Options menu (further settings):
• Press the control button for longer than 6 seconds
NOTE: After 30 s without any entry being made, the display jumps back to level
1 (indication of the operating status). Temporary, non-acknowledged modifi-
cations are discarded.
Installation and operating instructions Siriux/Siriux-D/Siriux-O
, , display position
English
63