Operating Instructions; Cleaning The Air Filter - Stihl FS 56 Manual De Instrucciones

Engine does not start in warm start
position <
Move the choke knob to g and
N
continue cranking until the engine
runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Fuel tank run until completely dry
After refueling, press the manual
N
fuel pump bulb at least five times –
even if the bulb is filled with fuel.
Set the choke knob to suit the
N
engine temperature.
Start the engine.
N
FS 56, FS 56 R, FS 56 C, FS 56 RC

Operating Instructions

During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".

Cleaning the Air Filter

If there is a noticeable loss of engine
power
3
1
Move the choke lever (1) to <.
N
Turn the screw (2) in the filter
N
cover (3) counterclockwise until the
cover is loose.
Ease the filter cover (3) over the
N
choke lever and lift it away.
Clean away loose dirt from around
N
the filter.
English
2
33