Stop The Machine; Adjust The Trimmer Head Angle; Maintenance; Clean The Machine - GreenWorks G40PSH Manual Del Operario

2. Press the trigger at the same time.
3.2

STOP THE MACHINE

Figure 6.
1. Release the trigger to stop the machine.
3.3 ADJUST THE TRIMMER HEAD
ANGLE
Figure 7
The trimmer head pivots 135° and can be locked into 7
positions within that range.
1. Pull the pivot button and move the head forward or
backward to your desired position.
2. Release the pivot button.
WARNING
The trimmer head should lock securely in place.
4

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
4.1

CLEAN THE MACHINE

WARNING
Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
4.2

LUBRICATE THE BLADE

To increase the efficiency and life of the blades,
lubricate them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to
remove more dirt.
English
• Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
5

STORE THE MACHINE

Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged
components. If it is necessary, replace the damaged
components, tighten screws and bolts, or speak to a
person of an approved service center.
4. Store the machine in a cool and dry location.
6

TROUBLESHOOTING

Problem
The motor does
not start when
you pull the trig-
ger.
The machine
smokes during
operation.
The motor is on,
blades do not
move.
5
NOTE
NOTE
Possible cause Solution
Make sure that
The battery pack
you tighlty install
is not installed
the battery pack
tightly.
in the machine.
The battery pack Charge the bat-
is out of power. tery pack.
1. Immediately
stop the ma-
chine.
The machine 2. Remove the
has damage. battery pack.
3. Speak to
service cen-
ter.
Do not use the
The machine machine and
has damage. speak to service
center.
Remove battery
The blades are pack then clear
blocked. blockage from
the blades.
EN