U.S. Products TORRENT Instrucciones De Uso página 4

A - ENGLISH
SWITCH PLATE CONTROLS: (REFER TO FIGURE 1)
1 Vacuum I Switch: Turns on/off vacuum motor I.
2 Vacuum II Switch: Turns on/off vacuum motor II.
3 Dump Pump Switch: Turns on/off dump pump. Float switch on recovery tank automatically turns
the pump on when the solution level in the tank reaches a pre-set level AND the switch is on the
ON position.
4 High Pressure Pump Switch: Turns on/off the high pressure (400-1200 psi) pump.
5 Dual Cord Sensor Light: The green light will turn on only when the two power cords are plugged
into separate circuits.
6 Hour Meter: Keeps track of the overall time the pump has been in use.
FRONT PANEL: (REFER TO FIGURE 2)
7 Pressure Gauge: Measures outlet pressure of high pressure pump in pounds per square inch (psi).
8 Ammeter: Allows precise adjustment of the pump outlet pressure without overloading the pump motor. Proper adjustment for maximum
pressure is at the break line between green and yellow.
NOTE: Since voltage can vary from one power outlet to another, setting the pressure adjustment based on amp draw will extend the life of
the motor by keeping the current within the correct range.
9 Pressure Adjustment Knob – Adjusts outlet pressure between 400 – 1200 psi. Note: you must trigger the tool and spray to see adjustment
of pressure. Clockwise increases and counterclockwise decreases pressure. Let the pump run for about one minute, then adjust the pump
using the ammeter for maximum pressure (set at the break line between green and yellow). For lower pressure, down to 400 psi, simply turn
the knob counterclockwise - while spraying - and watch the pressure gauge.
10 High Pressure Quick Disconnect – Attachment for high pressure solution line.
11 Auto-Dump Hose Fitting – Male garden hose fi tting to attach dump hose.
12 Direct Feed-Hose Fitting – Female garden hose fi tting to attach the direct water feed-hose. The feed hose has a chemical siphon system
and backfl ow preventer at the faucet end of hose.
13 Oil Level View Port - Allows viewing of the pump oil level sight-gauge.
14 Vacuum Motor Cover
15 Recovery Tank Lid
16 Latch
17 Castor
18 Wheel
19 Switch Plate
20 Dual Cord Sensor Light
21 Hour Meter
22 Power Cord
A - 4
INSTRUCTIONS FOR USE
TORRENT - 56041839
revised 1/12
1 2 3
4
5
6
FIGURE 1
1/12