U.S. Products TORRENT Instrucciones De Uso página 7

revised 1/12
AUTO-FILL:
Without Chemical Injection:
Simply connect one end of the water supply hose to a convenient water supply, and connect the other end to the water inlet fi tting on the machine.
NOTE: hot water cleans better than cold water. When all set-up and ready to begin cleaning, turn on the water supply.
With Chemical Injection:
Chemical Supply:
Place the container of concentrated chemical cleaner -- use a product with a pH between 6 and 10 to avoid premature pump wear, which would
void the warranty -- in a sink or near the water supply. Insert the end of the clear tubing with the foot valve attached into the chemical container.
NOTE: the ceramic weight at the foot valve will keep the valve at the bottom of the container.
Connect the chemical injector to the threads on a water supply (utility sink, garden hose). Bring the clear tubing from the chemical container to the
metering tip.
METERING TIP FLOW RATES
COLOR OZ/GAL
TAN 0.45
ORANGE 0.636
TURQUOISE 1.1
PINK 1.38
GRAY 4.36
The metering tip is replaceable. Change the metering tip to adjust the amount of chemical used per job. Refer to the fl ow rate chart
above and included with your metering tips.
To change the metering tip, carefully unscrew the tip that is installed and replace it with the tip of your choice. Put the tip you
removed in a safe and clean location.
NOTE: the Torquiose tip is installed at the factory.
CHEMICAL INJECTOR & WATER CONNECTION ASSEMBLY
The solution hose to the
machine attaches here
1/12
INSTRUCTIONS FOR USE
Direction of fl ow
56041839 - TORRENT
Metering Tip
CHEMICAL INJECTOR
ENGLISH - A
Connects to the
water source
A - 7