Puréeing - Silvercrest SHMS 300 C2 Instrucciones De Uso

Puréeing
WARNING! RISK OF INJURY!
► Never use containers made from glass or
other easily breakable materials. These con-
tainers may be damaged and cause injuries.
ATTENTION! PROPERTY DAMAGE!
► Never use the blender
such as: coffee beans, ice cubes, sugar, cereals,
chocolate, raw/hard vegetables etc. This could
result in serious damage to the appliance.
► Do not use the blender
food (e.g. soups). Remove the pot from the
hotplate before puréeing.
1) Use the blender
Kneading
Whisks
hooks for
for stirring
kneading
batter or cake
heavy doughs,
mixture or
e.g. yeast
for whipping
dough.
cream.
2) Open the safety catch of the blender socket
by pushing it to the side and holding it firmly.
NOTE
► The blender can only be used if the whisks
or the kneading hooks
3) Push the blender
and push it down firmly. The blender
audibly click into place.
4) To avoid overflowing, the container used for
blending should only be filled to about 2/3 of
its capacity. Select a suitably large container.
■ 50
│ GB│MT
for hard foodstuffs
to purée boiling
to purée foods.
Blender
for puréeing
fruits/
vegetables,
e.g. apples.
are not installed.
into the blender socket
NOTE
► Ensure that there is a sufficient amount of
liquid/purée in the purée container.
To ensure effective mixing of the ingredients,
the food should cover at least the lower section
of the blender
► Do not switch the hand mixer on until the
blender
dients.
5) Press the Turbo button /
button /
procedure. The appliance stops as soon as it
is released.
ATTENTION! PROPERTY DAMAGE!
► Do not operate the blender
than 1 minute at a time. After one minute of
use, allow the appliance to cool down fully.
6) When you have finished working with the
blender
remove the mains plug from the power socket.
ATTENTION! PROPERTY DAMAGE!
► Clean only the lower section of the blender
under running water. Do not allow water to
get inside the blender
damage to the appliance.
7) To remove the blender
socket
on both sides of the hand element
the same time. The blender
from the blender socket
8) Remove the blender
from the blender socket
must
.
has been inserted into the ingre-
. Keep the Turbo
pressed down during the whole
for longer
, release the Turbo button/
. This could result in
from the blender
, press the blender release button
is now released
.
with a snapping motion
.
SHMS 300 C2
and
at