Stop; After Use; Routine Maintenance; General Information - Stiga AB 500 Li 48 Manual De Instrucciones

6.4.1 Adjusting the speed
it is always advisable to set the rotor speed in
relation to the type of material to be removed
using the button (Fig. 5.B).removed:
– low blowing speed to move light material
and small branches on the lawn;
– medium blowing speed to move grass and
light leaves on asphalt or packed soil;
– high blowing speed (3 LEDs lit,
Fig. 5.D) for heavier materials such
as fresh snow or bulky dirt.
6.4.2 Advice for operation
Proceed slowly keeping the end of
the blower tube at a suitable distance
from the ground (Fig. 4).
To avoid dispersing the material to be
removed, direct the air flow towards the
outer edges of the pile of material. Never
direct the air flow to the middle of the pile.

6.5 STOP

To stop the machine:
1. release the throttle control lever (Fig. 5.F);
2. deactivate the safety button (Fig. 5.A)
3. wait until the cutting means stops.
It takes a few seconds for the rotor to
stop after the machine has been turned off.
Always stop the machine:
– when moving between work areas.
When moving, never leave your
hand on the throttle control in order
to avoid accidental start-ups.

6.6 AFTER USE

• Remove the battery from its housing
and recharge it (par. 7.2.2).
• Allow the motor to cool before
storing in an enclosed space.
• Clean (par. 7.3).
• Check there are no loose or damaged
components. If necessary, replace
the damaged components and tighten
any screws and loose bolts or contact
the authorised service centre.
IMPORTANT Always remove the
battery (par. 7.2.2) whenever the machine
is unused or left unattended.

7. ROUTINE MAINTENANCE

7.1

GENERAL INFORMATION

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these indications to avoid
serious risks or dangers.
Prior to carrying out any
maintenance operation, you need to:
• stop the machine;
• Remove the battery from its housing
and recharge it (par. 7.2.2);
• allow the motor to cool before
storing in an enclosed space;
• use suitable clothing, protective
gloves and goggles;
• read the relevant instructions.
Warning! Risk of injuries due
to dangerous moving parts!
– The frequency and types of maintenance
are summarised in the "Maintenance
Table" (see chapter 12). The table will
help you maintain your machine's safety
and performance. It summarises the
main interventions to be made and the
frequency applicable to each of them.
Carry out the relevant task as soon
as it is scheduled to be performed.
– The use of non-genuine spare parts and
attachments could adversely affect machine
operation and safety. The manufacturer
declines all liability for any damage or
injuries caused by these products.
– Genuine spare parts are supplied by Au-
thorised Assistance Centres and Dealers.
IMPORTANT Any maintenance and
adjustment operations not described in
this manual must be carried out by your
dealer or Authorised Service Centre.

7.2 BATTERY

7.2.1 Battery power reserve
Battery power reserve (and therefore
the cuttable area before recharging
is required) mainly depends on:
EN - 11