Parts Identification; Preparation; Charging The Shaver - Panasonic ES‑LV67 Manual De Instrucciones

Parts identification

A Main body
1 Protective cap
2 System outer foil
3 Foil frame
4 Foil frame release
buttons
5 Power switch
6 Lamp display
a. Shaving sensor
lamp ( )
b. Battery capacity
lamp
c. Switch lock lamp
( )
d. Charge status
lamp ( )
7 Appliance socket

Preparation

Charging the shaver

• Turn the shaver off.
• Wipe off any water droplets on the appliance socket.
ES-LV67_EU.indb 13
8 Outer foil section
9 System outer foil
release buttons
 Inner blades
 Trimmer
 Trimmer handle
B AC adaptor (RE7‑87)
 Adaptor
 Power plug
 Cord
 Appliance plug
Accessories
C Travel case
D Cleaning brush
E Oil
F Operating Instructions
G Guarantee Card
1
Insert the appliance plug
[B] into the shaver�
2
Plug the adaptor [B] into
a household outlet�
• Check that the charge status
lamp ( ) is glowing.
• Charging is completed after
approx. 1 hour.
3
Disconnect the adaptor
after charging is completed�
Note
You cannot operate the shaver while charging.
While charging
glows.
The number of the battery
capacity lamp will increase
as charging progresses.
Notes
• When charging the shaver for the first time or when it
has not been in use for more than 6 months, the
charging time may change or the charge status lamp
( ) may not glow for a few minutes. It will eventually
glow if kept connected.
2
1
After charging is completed
All the battery capacity
lamp and will glow and
then turn off after
5 seconds.
13
2019/06/05 19:10:16