KENMORE ELITE 111.7269 Manual De Uso Y Cuidado página 17

HOW TO INSTALL THE FREEZER DRAWER
1. Retract the inner rail track fully into the outer rail track
before installing freezer drawer. With the aid of an
assistant, align the rail ends with the rail guides located
on the sides of the cabinet.
Make sure that the gear teeth are engaged to the rail
guides the same amount on both sides.
2. Fully push in and close freezer drawer to engage rails
with rail support locking tab, applying a bit of pressure
after the door is closed to seat the tabs to the rail.
CAUTION : Make sure the tabs are completely
engaged to the rail or the refrigerator drawer could be
pulled out of the refrigerator by the user. Fully open the
freezer door to check and see if the locking tabs are
fully engaged. If they are not engaged, gently push
each freezer rail with a flat head screwdriver towards
the freezer compartment until the locking tabs snap to
the locked position.
This shows that
the tab is not
fully locked
FDR 30Cuft_UCG(영+스)(Kenmore).indd 17
REFRIGERATOR INSTALLATION
If the tab is not fully engaged,
use a flat screwdriver to push
on the rail as shown to allow
the tab to snap into position
This shows that the
tab is fully in the
locked position
3. Replace the lower freezer drawer basket.
4. Insert the upper freezer drawer above the lower basket.
5. Open and close the freezer drawer several times to
make sure operation is smooth and seal is consistent all
the way around the freezer compartment.
CAUTION : Do not hold the handle when removing or
replacing the drawer. The handle may come off and
could cause personal injury.
17
2019-10-14 오전 10:30:20