Legal Information - Ottobock 4R103 Instrucciones De Uso

Moving the adapter
Tools required:
>
710D4 torque wrench
> No load on the prosthesis, or the prosthesis is not being worn.
1) Loosen the two cap screws of the dovetail guide (see Fig. 1).
2) Move the proximal section of the tube clamp adapter in the dovetail
guide. Note the maximum displacement (see Fig. 2).
3) Tighten the two cap screws (installation torque: 15 Nm).
6 Cleaning
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
7 Maintenance
► The prosthetic components should be inspected after the first 30 days of
use.
► Inspect the entire prosthesis for wear during normal consultations.
► Conduct annual safety inspections.
8 Disposal
This product may not be disposed of with regular domestic waste in all juris­
dictions. Disposal that is not in accordance with the regulations of the coun­
try where the product is used may have a detrimental impact on health and
the environment. Please observe the information provided by the responsible
authorities in the country of use regarding return, collection and disposal
procedures.

9 Legal Information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
9.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregard of this
document, particularly due to improper use or unauthorised modification of
the product.
14 | Ottobock