Replacing Parts; Instructions And Warnings For The Replacement Of Parts; Replacement Of The Burner Nozzle - Angelo Po 0N1CP1GH Manual De Uso

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS

Important
Before carrying out any replacement procedure,
activate all the safety devices provided and deci-
de whether staff at work and those in the vicinity
should be informed.
In particular, turn off the gas supply tap, cut
off the electricity supply using the master
switch and prevent access to all devices that
might cause unexpected health and safety
hazards if turned on.
To carry out this operation, proceed as follows.
Open the hatch (A).
1)
Undo the screws to remove the drain lever
2)
(B).
Undo the screws to remove the panel (C).
3)
3269830_inst_GB_rev.2

REPLACING PARTS

REPLACEMENT OF THE BURNER NOZZLE

A
B
C
Also make sure that during the maintenance
procedure, that the operator is always able
to check whether the plug is disconnected
from the power outlet.
If work parts have to be replaced, use original
spare parts only. The manufacturer declines
all responsibly for injury or damage to com-
ponents due to the use of non original parts,
or extraordinary work on the appliance which
may modify the safety requirements without
the manufacturer's authorisation. When or-
dering components, follow the instructions
provided in the parts catalogue.
Unscrew the nozzle (D) and replace it with
4)
the one suitable for the type of gas in use (see
table at back of manual).
Replace all when the operation is complete.
5)
D
- 15 -
GB
ENGLISH