Safety Devices; Safety And Information Signs - Angelo Po 0N1CP1GH Manual De Uso

Even if the equipment has all its safety devices,
if necessary, during the installation and connec-
tion other safety devices may be supplemented
in accordance with applicable laws.
The illustration shows the position of the devices.
Gas supply tap: for turning the connection to
A)
the gas supply line on and off .
Safety thermocouple: cuts out the gas sup-
B)
ply if the fl ame goes out.
Pressure switch: stops gas supply when
C)
the water level in the tank drops below the
minimum level.
Important
Make a daily check that the safety devices are
properly installed and in good working order.
The illustration shows the position of the signs
provided.
Nameplate with manufacturer and applian-
A)
ce data .
General hazard:read the manual carefully
B)
before carrying out any procedure.
General hazard: when washing the applian-
C)
ce do not point pressurised water jets at
internal parts.
General hazard: all relevant regulations
D)
must be complied with. "No liability is ac-
cepted in case of failure to comply with the
installation and commissioning instructions".
General hazard: all relevant regulations
E)
must be complied with. "Install in complian-
ce with the relevant regulations and use in
well ventilated premises only".
Burn hazard: watch out for hot surfaces.
F)
CE marking: this indicates that the equip-
G)
ment is compliant with all relevant laws ap-
plicable to the product.
3269830_ut_GB_rev.2

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

- 5 -
B
C
B
C
D
E
H
37M3162
L
General hazard: dry operation is forbidden.
H)
General hazard: drain the well completely
L)
after use.
A
C B
GB
F
37M3202
G
A
ENGLISH