Description Of Controls (Pic.1); Preliminary Checks And Start-Up - OP TUBOMATIC H54 EL Manual De Uso

OP S.r.l.
Via Serpente 97 25131 Brescia Italia Tel. +39.030.3580401 Fax. +39.030.3580838
________________________________________________________________________________________________
DESCRIPTION OF CONTROLS (PICTURE 1)
1. "POWER SWITCH".
Connects the machine to the power supply.
2. "START" BUTTON.
This button should be pressed to start working after an emergency stop or after a
power outage.
E
3. "OPEN" BUTTON.
N
When this button is pressed the piston moves back and the clamps open. When the
G
button is released the piston stops.
L
4. "CLOSE" BUTTON.
I
When this button is pressed the piston advances and the clamps grip the union.
S
H
5. "EMERGENCY STOP".
When this button is pressed the fitting machine stops immediately. To restore
operation, unlock the button by turning it in the direction of the arrows and press the
"START" button.
6. WORKING LED.
Once the crimping diameter has been reached, the indicator light on the front of the
machine will come on.
7. RED LED.
When the red indicator light is
machine with the start button when the light has switched off.
8. "STOP" BUTTON.
When this button is pressed the fitting machine stops immediately.
9. RED LED.
When the red indicator light is on, the proximity is not working.

PRELIMINARY CHECKS AND START-UP

• Place the machine on a stable flat surface and in a position comfortable for the
operator.
• Make sure that the oil is at the required level.
• Make sure that the parts subjected to friction are clean and greased once every 6
months.-(recommended oil KLUBER STABURAGS NBV30).
• Turn on the power supply, turn the general switch, push the start button, and make
sure that the motor turns clockwise (on the motor, an arrow indicates the exact
direction of rotation; if this is not the case, it is necessary to reverse the power supply
phases).
• Run a test on the piston's forward and return travel in order to verify that everything
works without any problems.
• The motor doesn't work when the switch is connected :
1. Check whether the emergency button is locked.
2. Check whether the wall switch corresponds to the machine's switch poles.
3. Check whether the fuse of the wall switch is burnt.
4. Check all the fuses of the electric system of the machine.
on, this means the engine is heating. Reset the
40