Clamp Selection; Optional Machine Accessories - OP TUBOMATIC H54 EL Manual De Uso

OP S.r.l.
Via Serpente 97 25131 Brescia Italia Tel. +39.030.3580401 Fax. +39.030.3580838
________________________________________________________________________________________________
• To maintain the original characteristics and validity of certification use
engine with thermal pellet.
• Attention: after turning the master switch, wait a few seconds while the
power supply is loading.

CLAMP SELECTION

note: THE SERIES OF CLAMPS INDICATED IN THE FOLLOWING TABLE ARE AVAILABLE
FOR THE TUBOMATIC H54. ORDER THE NECESSARY SETS OF CLAMPS.
ON REQUEST, WE CAN SUPPLY CLAMPS WITH SPECIAL NOMINAL DIAMETERS.
TABLE B: DATA ON AVAILABLE CLAMPS
Order code
TUBH54M10
TUBH54M12
TUBH54M14
TUBH54M16
TUBH54M19
TUBH54M22
TUBH54M25
TUBH54M29
TUBH54M34
TUBH54M38
TUBH54M42
TUBH54M46

OPTIONAL MACHINE ACCESSORIES

The machine can be equipped with a cabinet which is to be chosen between two models:
Cabinet for manual clamp replacement.
•
Cabinet for rapid clamp replacement.
•
If manual replacement is chosen, we recommend the simple cabinet (picture 7). It offers
an excellent supporting surface and provides shelves where the clamps can be put away
after their use.
If rapid clamp replacement is chosen, the complete cabinet is necessary (picture 8),
equipped with clampholder shells and special pliers.
Ø minimum pressable (mm):
10
12
14
16
19
22
25
29
34
38
42
46
41
Ø maximum pressable
(recommended):
12
14
16
19
22
25
29
34
38
42
46
54
E
N
G
L
I
S
H