Tabla de contenido
Publicidad
Names of things and what they do
Panel
fig.panel1
1
2
3
4
1 .....Mic input jacks 1, 2 (INPUT 1, 2)
These are input jacks for analog audio. Each jack can be used either as an XLR type or phone type
jack. You can use either a balanced or unbalanced connection for either type.
The XLR type jacks provide 48 V phantom power, allowing you to use condenser mics that require
phantom power. If you are using such a mic, turn the phantom power switch on.
fig.jack-2
* This instrument is equipped with balanced (XLR/
TRS) type input jacks. Wiring diagrams for these jacks
are shown at right. Make connections after first
checking the wiring diagrams of other equipment you
intend to connect.
fig.jack-1
* Always turn the phantom power off when connecting any device other than
condenser microphones that require phantom power. You risk causing damage if
you mistakenly supply phantom power to dynamic microphones, audio playback
devices, or other devices that don't require such power. Be sure to check the
specifications of any microphone you intend to use by referring to the manual that
came with it.
(This instrument's phantom power: 48 V DC, 10 mA Max)
2 .....Input level knobs (GAIN)
These knobs adjust the input level to the mic input jacks.
3 .....Plug-in powered input
This jack allows connection of a miniature condenser mic that requires a power supply. 5 V of
power is supplied from the plug-in powered mic input. Only a plug-in power compatible mic may
be used with this input. If mics are connected to both the plug-in powered mic input and to mix
input jack 1 (XLR type/phone type), the signal from mic input jack 1 (XLR type/phone type) will
be ignored.
* If a mic is connected to the plug-in powered mic jack, the input level knob (GAIN) will not adjust the
input level.
12
6
5
7
8
9
1:GND
2:HOT
HOT(TIP)
3:COLD
10
11
GND(SLEEVE)
COLD(RING)
XLR plug
TRS phone
Phone plug
plug
(unbalanced)
(balanced)
Publicidad
Tabla de contenido
