Ground Terminal; Block Diagram - Edirol M-100FX Manual Del Proprietário

Names of things and what they do

36 ...Ground terminal

In some cases, depending on the environment in which the unit is installed, the surface of the panel
may sometimes feel rough and grainy. This is due to an infinitesimal electrical charge, which is
absolutely harmless. However, if you are concerned about this, connect the ground terminal (see
figure) with an external ground. When the unit is grounded, a slight hum may occur, depending
on the particulars of your installation. If you are unsure of the connection method, contact the
nearest Roland Service Center, or an authorized Roland distributor, as listed on the "Information"
page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event
of lightning)
37 ...Security Slot (
http://www.kensington.com/

Block diagram

The following diagram shows the signal flow within the M-100FX.
fig.block
M-100FX BLOCK DIAGRAM
MONO INPUTS
GAIN
MIC1
FX SW
GAIN FX SW
MIC2
STEREO INPUTS
LINE3/4 LINE5/6
EQ
LEFT
EQ
RIGHT
LINE7/8 LINE9/10
LEFT
EQ
RIGHT
EQ
STEREO AUX RETURN
LEFT
RIGHT
USB AUDIO IN LEVEL
18
)
AUDIO/
VOICE
EFFECTS
PAN
EQ
PAN
EQ
LEVEL
BALANCE
LEVEL
BALANCE
AUX RETURN LEVEL
USB MIX DOWN SW
MASTER BUS
LEFT RIGHT AUX
L / R
USB BUS
SEND
SEND
SEND
SEND
REVERB
(internal)
AUX
PHONES LEVEL
MONITOR OUT LEVEL
LEFT
RIGHT
MASTER OUT LEVEL
LEFT
RIGHT
LEFT
RIGHT
MASTER OUT LEVEL
LEFT
RIGHT
AUX SEND
PHONES
MONITOR OUT
LEFT
RIGHT
MASTER OUT
LEFT
RIGHT
DIGITAL OUT
USB AUDIO
OUT
IN