Windows 98 Users - Edirol M-100FX Manual Del Proprietário

Connecting the M-100FX to your computer

Windows 98 users

The USB composite device driver is installed first, then the USB audio
device driver is installed. Use the following procedure to install the drivers.
1.
With the M-100FX disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse
(if used).
2.
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit it as well.
3.
Place the M-100FX's ADVANCE (mode select) switch in the OFF position.
fig.advance-off
Advanced mode is off
4.
Use the USB cable to connect the M-100FX to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
M-100FX.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the M-100FX to your computer.
5.
Set the M-100FX's power switch to the ON position.
6.
USB composite device will be detected automatically, and the "Add New
Hardware Wizard" dialog box will appear.
Click [Next].
fig.05-25e_50
128
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong order,
you risk causing
malfunction and/or
damage to speakers and
other devices.
Always make sure to have
the volume level turned
down before switching on
power. Even with the
volume all the way down,
you may still hear some
sound when the power is
switched on, but this is
normal, and does not
indicate a malfunction.
If this dialog box does not
appear, refer to "Find new
hardware wizard" does
not execute automatically
(p. 173).