Before inspecting or servicing this machine, make
sure the engine is off and no parts are moving.
Disconnect the spark plug wire and move it away
from the spark plug.
Maintenance Schedule
Pre-Operation Steps
Before starting the engine, perform the following pre-operation steps:
•
Check the level of the engine oil and the fuel tank level. Check for any leakage.
•
Check fuel hose for cracks or damage. Replace if necessary.
•
Make sure the air filter is clean.
•
Remove any dirt and debris that has collected on the generator and around the muffler and control panel.
•
Inspect the work area for hazards.
After Each Use
• Shut off the engine.
• Store unit in a clean and dry area.
ITEM
Check condition. Adjust gap and clean.
Spark Plug
Replace if necessary.
Engine Oil
Check oil level.
Replace.
Air Filter
Clean, replace if necessary.
Clean fuel filter and fuel tank strainer.
Fuel Filter
Replace if necessary.
Check fuel hose for cracks or other
Fuel Line
damage. Replace if necessary.
Exhaust System
Inspect muffler and spark arrester
Check spark arrester screen. Clean/replace
if necessary.
Clean
Remove any dirt or debris from unit.
Starting System
Check recoil starter operation.
Fittings/
Check. Replace if necessary.
Fasteners
Crankcase
Check for cracks or damage. Replace if
Breather Hose
necessary.
De-carbonize. See authorized service
Cylinder Head
representative.
Check and adjust. See authorized service
Valve Clearance
representative.
English
MAINTENANCE
MAINTENANCE
PERIODIC MAINTENANCE
PERIODIC MAINTENANCE
NOTES
14
If you are unsure of how to perform a maintenance
task, have the unit serviced by an authorized service
representative. Only use replacement parts specified
in this manual.
After 8 hours or
6 Months (100
Daily
Customer Hotline 1-800-445-1805
12 Months
hours)
(300 hours)