Fuel Tank Filter; Fuel Filter; Storage And Transportation Of The Generator - Powermate PM0152000 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fuel Tank Filter

To clean, remove fuel cap and filter.
Clean filter with gasoline.
Wipe the filter with a clean rag.
Install filter
Install fuel cap.

Fuel Filter

To clean, remove screws, remove outer casing, and drain fuel.
Lift and hold onto the clamp, then remove hose from tank.
Remove fuel filter.
Clean filter with gasoline.
Wipe the filter with a clean rag and return filter to tank.
Install hose and clamp.
Open fuel valve. Inspect for leakage.
Install outer casing and tighten screws.

Storage and Transportation of the Generator:

When transporting the generator, turn the 3 in 1 Start Switch (ON / OFF and Choke) to the OFF position. Keep the generator
level to prevent fuel spillage. Fuel vapor or spilled fuel may ignite.
Remove and debris that has collected on the generator and around the muffler and control panel. Use a brush or vacuum to
remove loose dirt.
Inspect air cooling slots. Remove any debris if obstructed.
For short-term storage, start the generator once every 7 days.
For semi-long term storage, add fuel stabilizer to prevent stale fuel from causing acid and gum deposits in the fuel system
and carburetor.
For long-term storage, drain the fuel.
Store indoors to prevent freezing and use a protective cover to protect from dust.
The generator must be Shipped, Run, and Stored in the upright position as shown below.
English
MAINTENANCE
MAINTENANCE
18
Customer Hotline 1-800-445-1805

Publicidad

Tabla de contenido
loading

Tabla de contenido