Mounting And Transporting - Skil MS6305-00 Manual Del Propietário

MOUNTING AND TRANSPORTING

WARNING
Mounting the saw to the
workbench (Fig .13a, 13b)
WARNING
or bolt your miter saw to a workbench or an
approved miter saw stand . If a miter saw
stand is used, read the operator's manual and
follow the instructions for the miter saw stand.
Never operate your miter saw on the floor or in
a crouched position. Failure to heed this
warning can result in serious personal injury.
The sliding miter saw should be mounted to a
firm supporting surface such as a workbench,
mounting board, or miter saw stand. The
saw base has four mounting holes. If using
bolts or screws (not
be of sufficient length to accommodate the
saw base, lock washers, hex nuts, and the
thickness of the workbench or other mounting
surface. Tighten all bolts or screws securely.
The hole pattern for mounting to a workbench
is shown in Fig.13a.Carefully check the
workbench after mounting to make sure that
no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the
workbench to the floor before operating.
Temporary mounting, using clamps
If necessary, clamp the miter saw to a
•
workbench or table top.
Place two (2) or more "C" clamps on the
•
clamping areas and secure (Fig. 13b).
NOTICE: Always make sure you leave enough room in work area to accommodate long workpieces.
Transporting
WARNING
Unplug the electric cord and wind it up .
•
Never lift the saw by gripping any of the mechanism parts . The saw may move and
•
cause severe injuries to your fingers or hands.
To avoid back injury, hold the tool close to your body when lifting . Bend your knees so
•
you can lift with your legs, not with your back.
Never lift the tool by holding the main handle . This may cause serious damage to the tool.
•
Never lift the miter saw by the power cord . Attempting to lift or carry the tool by the power
•
cord will damage the insulation and the wire connections, and possibly result in electric
shock or fire.
Disconnect plug from power source before mounting or transporting miter
saw to avoid possible injury.
Before starting any
cutting operation, clamp
supplied), they should
To avoid injury, follow all statements identified below by the Bullet (•)
symbol .
Fig. 13a
Workbench
Base
Mounting holes
Fig. 13b
23