Inserting/Replacing The Battery - Bosch GLL40-20G Instrucciones De Funcionamiento Y Seguridad

condensation which is expected. In such conditions,
equipment is normally protected against exposure to direct
sunlight, precipitation, and full wind pressure, but neither
temperature nor humidity is controlled.
Use only alkaline batteries.
To open the battery lid 4, press the latch of the battery lid 3 and fold the
battery lid up. Insert the supplied batteries.
When inserting, pay attention to the correct polarity according to the
representation on the inside of the battery compartment.
When the batteries are low, the laser beams flash 0.3 s off, 0.3 s on, a
total of 3 times, repeating this cycle every 1 minute.
Always replace all batteries at the same time. Only use batteries from
one brand and with the identical capacity.
storing for extended periods, the batteries can corrode and discharge
themselves.
GLL40-20G 2610039425 7-18.indd 13
Preparation

Inserting/Replacing the Battery

Remove the batteries from the tool when
not using it for extended periods. When
-13-
12/31/18 9:26 PM