Waeco PerfectView CAM60ADR Instrucciones De Montaje página 31

PerfectView CAM60ADR
 The most secure type of attachment is with screws fitted through the
body. Please observe the following instructions:
– There must be sufficient space for the mounting procedure behind the
chosen installation location.
– Suitable measures must be taken to prevent water penetrating through
any holes made (e.g. by using screws and sealant and/or spraying the
outer attachment parts with a sealant).
– The location on the body where you wish to attach the camera must
be rigid enough to allow the camera to be tightly fastened.
 Check beforehand that there is sufficient room for the drill head to come
out on the other side (fig. 2, page 4).
 If you are not sure about the location you have chosen, consult the vehicle
manufacturer or dealer.
I
NOTE
We recommend greasing the threads of the bolts to prevent
corrosion.
When mounting the camera, proceed as follows:
➤ Hold the camera on the chosen location and mark at least two different
points for the drill holes (fig. 9, page 6).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
If you want to screw on the camera with self-tapping screws
(fig. 0, page 6)
A
NOTICE! Risk of damage!
The holder may only be attached to steel panels with a minimum
thickness of 1.5 mm using self-tapping screws.
➤ Drill Ø 4 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the 5 x 20 mm self-tapping screws.
EN
Mounting the camera
31