Metrix ScopiX IV OX 9062 Manual De Instrucciones página 96

Tabla de contenido

Publicidad

INITiate:CONTinuous:NAME
INITiate[:IMMediate]:NAME
INPut{[1]|2|3|4}:COUPling
INPut{[1]|2|3|4}:DMM
:COUPling
INPUT:DMM
:BANDwidth:RESolution
MEASure:AC?
MEASure:AMPLitude?
MEASure:CURSor:DTIME?
MEASure:CURSor:DVOLT?
(Command)
INIT:CONT:NAME <EDGE|PULse|DELay|EVENt>,<1|0|ON|OFF> starts or stops the
acquisition in repetitive mode in the indicated trigger mode.
In the CAPTure mode, the capture of faults in (Recorder) files is used.
(Command)
INIT:NAME <EDGE|PULse|DELay|EVENt> runs an acquisition in single mode.
(Command/Query)
The INP{[1]|2|3|4}:COUP <AC|DC|GROund> command selects the coupling of the selected
channel.
To the question INP{[1]|2|3|4}:COUP?, the instrument returns the coupling of the selected
channel.
(Command/Query)
The INP{[1]|2|3|4}:DMM:COUP <AC|DC|GROund> command affects the coupling of the
selected channel.
To the question INP{[1]|2|3|4}:DMM:COUP? the instrument returns the current coupling of the
selected channel.
(Commande/Query)
The INP{[1]|2|3|4}:DMM:BAND:RES <bandwidth> command limits the channel bandwidth to
a value among : 625 Hz, 5 kHz, 0 (no limit), directly higher or equal to the required value.
To the question INP{[1]|2|3|4}:DMM:BAND:RES? the instrument shows the cutoff frequency
of the low-pass filter in use (625 Hz, 5 kHz or 0).
(Query)
To the question MEAS:AC? <INT{1|2|3|4}>,<CYCle|INTerval> the instrument returns the
RMS voltage over an integer number of periods (CYCle) or over the measurement interval
(INTerval).
Response format:
<measured value><NL>
value in format <NR3> expressed in volt.
(Query)
To the question MEAS: AMPLitude? <INT{1|2|3|4}> the instrument returns the amplitude of
the selected signal.
(Query)
To the question MEAS:CURS:DTIME?, the instrument returns the time delay between cursors
1 and 2.
Response format:
<measured value><NL>
value in format <NR3> expressed in second.
(Query)
To the question MEAS:CURS:DVOLT?, the instrument returns the difference between cursors
1 and 2.
Response format:
<measured value><NL>
value in format <NR3> expressed in volt.
96
Programación

Publicidad

Tabla de contenido
loading

Tabla de contenido