Error Messages/Troubleshooting - Beurer BC 57 Instrucciones De Uso

Step 4: BC 57:
data transfer immediately
following measurements.
• If Bluetooth ® data
transfer has been ac-
tivated, data is trans-
ferred after having
confirmed the user
memory and pressing
the START/STOP but-
ton .
The " beurer Health Manager" app must be active to
allow data transfer.
If your smartphone has a protective cover, remove this
to ensure that there is no interference during the transfer.
Begin the data transfer in the " beurer Health Manager"
app.
We would explicitly draw attention to the fact that the
software to hand is not a medical product in accordance
with EU Directive 93/42/EEC.
The values displayed are purely for visualisation purposes
and must not be used as a basis for therapeutic treat-
Step 4: BC 57:
Data transfer at a later
point:
• Go to memory mode
(chapter 7). Select the
desired user memory.
The Bluetooth ® transfer
starts automatically.
ments. The software is not part of a diagnostic-medical
system.

7. Error messages/troubleshooting

In case of faults, the EE_ message appears in the display.
Error messages may appear if:
• systolic or diastolic pressure could not be measured
( appears on the display)
• systolic or diastolic pressure was outside the measure-
ment range ( or
• the cuff is fastened too tightly or loosely (
on the display)
• the pump pressure is higher than 300 mmHg (
pears on the display)
• if the pressure during pumping up remains below
15 mmHg for longer than 3 minutes (
the display)
• there is a system or device error (
appears on the display)
• the data could not be sent via Bluetooth
In such cases, repeat the measurement. Ensure that you
do not move or speak. If necessary, reinsert or replace
the batteries.
33
appears on the display)
appears on
, ,
(
®
appears
ap-
or
).