Puky FITSCH Manual De Instrucciones página 8

Play tricycle Speeldriewieler
Small parts which are required during assem-
bly (e.g. screws and washers) must be kept
out of the reach of small children. There is a
danger of suffocation as a result of swallowing
the parts. Also keep all packaging materials
away from children.
In order to prevent accidents or injuries occur-
ring later, the assembly must be carried out
very carefully by an adult. Take sufficient time
to do this. Several assembly steps require
manual skill and practise in handling tools (e.g.
spanner). If you are unsure, then please con-
tact your specialist dealer or a workshop.
At several points it is necessary to tighten
screws with a certain force. This force is given
in Newton meters (e.g. 2 Nm). If a screw is not
tightened with sufficient force, then the con-
nection will possibly still be too loose and un-
safe. If the force is too great, then screws and
other parts may be damaged and destroyed.
Figure 1: Insert rear axle into the frame.
Align the square nut to the rear.
Figure 2: Insert screws and tighten.
Figure 3: Remove the washer (!) from the
transportation lock by loosening the
screw connection.
Figure 4: Slide the steering tube with bearing
shells all the way onto the fork shaft.
Place the washer back on and align
the lug of the fork shaft to the rear.
Figure 5: Slide the handlebar all the way onto
the fork shaft. Tighten the screw.
Align the slot in the handlebar to the
rear. Firmly press down the cap until
it snaps into position.
Figure 6: Slide the seat onto the frame from
the rear and screw tight.
Operation
Figure 7: Adjusting the seat position
Figure 8: State ready for use.
8