Dolmar MS-4300.4 U Instrucciones De Manejo Originales página 22

4. Wind the lines up firmly to the direction slown by left-hand (LH) arrow on the
flange. Do not cross the lines.
5. Wind all but about 100 mm (3-15/16") of the Cords, leaving the end
temporarily hooked through a notch on the side of the spool.
6. Put tab knob onto the housing hub, positioning it can freely move up and
down against spring tension. Put the spool into the housing, aligning the teeth
on spool and tap knob alternately like gears.
7. Put in the cutting lines through the slot of eyelets.
8. Put the cover onto the housing, aligning the tabs on cover and the windows
on housing. Make sure the cover is secured exactly to the housing. Outer
edge of cover locking tab and outer surface of the housing should be on
same circumference.
To "LH" direction
22
Wind tightly
100 mm from
notches
Tab knob's teeth
Spool's teeth
Cover locking tab
Housing window
Outer edge Outer
of cover surface of
locking tab housing