Adding Water And Ground Coffee; Brewing Coffee Now - MrCoffee PSTX Series Manual Del Usuario

2. Rinse the water filter in fresh water before first use.
3. Follow Adding Water and Coffee instructions.
4. When you are done brewing your coffee, rinse the
water filter with fresh water. Do not put your water
filter in the dishwasher.
To replace the water filter disks, twist
the gray disk cover from your water
filtration system. Remove the used disk.
Insert the new disk into the frame and
twist the cover back into place.
C. Adding Water and Ground Coffee
1. Open the brew basket drawer
(Figure 4).
2. Place a MR. COFFEE
®
cup paper basket-style filter or a
MR. COFFEE permanent filter into
®
the removable filter basket.
NOTE: If using paper filters, it is
important that the sides of the filter
fit flush against the side of the filter
basket. If filter collapse occurs,
dampen the filter before placing in
the filter basket and adding ground
coffee and water.
3. Add the desired amount of coffee
and gently shake to level the
coffee. See the Suggested Coffee
Measurement Chart (Figure 5).
4. Slide the brew basket back into
place (Figure 6).
5. Fill the removable water reservoir
with cold, fresh water to the
12
BVMC-PSTX_15ESM1.indd 13-14
brand 10–12
desired capacity (1 cup equals 5 ounces) For easy
and accurate filling, the water markings on the
removable water reservoir shows the amount of
water needed to make the corresponding desired
number of cups. Do not fill past the "10 cup MAX
line" or water will flow out of the coffeemaker.
NOTE: The amount of coffee brewed will
always be slightly less than the amount of water
poured in the water reservoir. This is due to
the minimum absorption of water by the coffee
grounds.

BREWING COFFEE NOW

1. After completing the steps in the Adding Water and
Figure 4
Coffee section and with the decanter
Figure 5
and the filter basket securely in
place, turn the coffeemaker on by
pressing the BREW NOW button once
(Figure 7). The BREW NOW light will
turn on and pulse to signal that the
coffeemaker is on and brewing.
2. After the used coffee grounds have
cooled, carefully remove the filter
basket and discard them.
NOTE: The brew basket drawer is hot after brewing. Always
allow the coffeemaker to cool down before cleaning.
3. Prior to making a second pot of coffee, turn the
coffeemaker off. This will reset the FRESH BREW™
TIMER feature. To turn the coffeemaker off, press the
BREW NOW/OFF button until all lights turn off.
4. Make sure the decanter is empty before starting to
brew coffee.
Figure 6
Figure 7
13
1/26/15 2:17 PM